19045 Farmington Road
Livonia, Michigan  48152
Phone (248) 476 - 4200
Fax (248) 476 - 5705

The Lighting Resource for Machine Vision

VISION-LIGHTS.COM

Products for Machine Vision

Sensor Enclosures (Stock)

PVS-30-ENC1 Sensor Enclosure

Phoenix Imaging manufactures several different types of sensor enclosures to fit our most popular cameras.  The PVS-20 & PVS-30 sensor enclosures are completely sealed with the sensor cable protruding a tight hole out the rear center of the enclosure.  The PVS-20 & PVS-30 sensor enclosures are available in either standard or long length models.  The housing is constructed of three pieces of solid aluminum precision machined and finished in a black anodize coating.  Butyl seals close all openings to the housing.  A 2" diameter borosilicate glass window protects the front of the optics.  The window is very tough and can be cleaned using standard window cleaner and paper towel.  The housing has 2) ¼-20 UNC mounting holes on two sides and the bottom of the enclosure for mounting.

CVM-50-ENC1 & CVM-50-ENC2 sensor enclosures

These camera enclosure are very similar to the PVS-20 & PVS-30 enclosure in terms of sensor mounting and lens sizes supported.  However, the rear of the sensor is exposed through the back of the housing.  This allow access to the switches, BNC and Hirose multi-pin connector(s).  The sensor is not fully enclosed in the housing and therefore should not be used in damp areas or locations with extreme operating conditions.

CVM-A-ENC1 & CVM-A-ENC2 sensor enclosures

These camera enclosure are similar to the CVM-50-ENC1 & CVM-50-ENC2 enclosure in terms of sensor mounting and lens sizes supported.  This family of enclosures is designed for house the JAI "A" series sensors, including the models A-50, A-60 & A-11.

The rear of the sensor is exposed through the back of the housing.  This allow access to the Hirose multi-pin connector(s).  The sensor is not fully enclosed in the housing and therefore should not be used in damp areas or locations with extreme operating conditions.

CVM-130-ENC1 sensor enclosure

These camera enclosure are similar to the CVM-50-ENC1 enclosure in terms of sensor mounting and lens sizes supported.  This family of enclosures is designed for house the Panasonic CF-130 series sensors.

The rear of the sensor is exposed through the back of the housing.  This allow access to the switches, BNC and Hirose multi-pin connector(s).  The sensor is not fully enclosed in the housing and therefore should not be used in damp areas or locations with extreme operating conditions.

Note: Other enclosure are added on a regular basis.  If you have a special request for a particular sensor please contact the plant for cost and delivery.

[ Up ] [ Latest News ] [ Lighting Products ] [ Lenses ] [ Sensor Enclosures ] [ Sensors ] [ Services ] [ Profile ]

Copyright © 2002- 2004 PHOENIX IMAGING
Last modified: May 17, 2004